Cited 2026 HVAC price ranges · free quotes from independent licensed prosGet free quotes →
HeatAndAirCost

2026 component pricing

HVAC part replacement costs

A technician names a part, and you have about a minute to decide whether the number attached to it is fair. Each page below prices one component with a researched 2026 range, the symptoms that point to it, and the cheaper fault it is commonly confused with.

By the HeatAndAirCost editors · Last updated September 14, 2026 · How we research prices

Installed part replacement cost at a glance. Each range is cited on its own page.
PartTypical 2026 rangeNotes
Capacitor$250–$400Cheapest common failure on both furnaces and air conditioners.
Furnace pressure switch$150–$400Often a blocked vent or drain rather than a bad switch.
Furnace inducer motor$400–$1,100Furnace locks out before the burners light.
Furnace blower motor$500–$2,300ECM variable-speed motors sit at the top of the range.
AC compressor$1,800–$2,800The repair that most often tips toward replacing the unit.

Price the part you were quoted

Open the page for the component on your quote. Every one lists what it does, why it fails, and what else to rule out before you approve the work.

Zoom back out

A single part is one line on a bill. For the whole job, check furnace repair cost or AC repair cost, add the service call fee if it is not being credited, and if the system is old, run the $5,000 rule before you spend on a part at all. The full index is on the cost guides hub.

Not sure which part failed yet?

If nobody has diagnosed the system, start from the symptom. The HVAC troubleshooting hub walks the free, no-tool checks for a furnace that will not start, a furnace blowing cold, and an AC that runs without cooling. Plenty of calls end there, with no part replaced at all.

Every range on these pages is compiled from published cost research and cited on the page it appears on. Read how we research prices or who runs HeatAndAirCost. We are not a contractor and the figures are researched ranges, not quotes.

People also ask

HVAC part cost FAQs

Which HVAC part fails most often?

Capacitors, igniters, flame sensors, and contactors are the parts technicians replace most, and they are also the cheapest. A capacitor runs $250 to $400 installed. That is worth knowing because several expensive-sounding symptoms, like a blower that hums but will not spin, are often a failed capacitor rather than a failed motor.

How do I know the quoted part is the part that actually failed?

Ask the technician what test confirmed it. A capacitor is checked with a meter against its rated microfarad value, a pressure switch is confirmed by checking the vent and drain for a blockage first, and a blower motor is tested before it is condemned. A written diagnosis that names the test is the difference between a repair and a guess.

Is it cheaper to replace one part or the whole system?

One part is almost always cheaper today. The question is whether it is cheaper over the next few years. Multiply the age of the system by the repair quote: above roughly $5,000 the replacement case gets strong, and a big-ticket part like a compressor on a system past twelve years usually loses that math.

Do these part prices include labor?

Yes. Every range on the linked pages is the installed price, part and labor together, based on published 2026 cost research. A separate diagnostic or service call fee of $75 to $200 may be charged before the repair begins, and some contractors credit it toward the work.

Got a quote?

See if it’s a fair price

Compare the part on your quote against the ranges above, then get free quotes from independent, licensed HVAC contractors when you are ready.